Setup: Allows setup of the comment you want in the header of each print; such as customer name or any other comment.

Changing the printer will change the default printer. If the printer changed a button to reset the startup default printer will be available.

Select what you want to print with the check boxes, click print

Break Lines will give the X,Y end points relative to point 0,0.

The CNC Program will not check unless the file has been written.

Shown is a preview of the basic output settings for quick reference.

Setup: Allows the setup of CNC codes etc.

Write: Displays the setup dialogue to confirm the output settings. On exit a file dialogue is displayed, save the CNC program.

Open: Opens the file in your text editor. This option is not enabled until a file is written.

Message: Shows the current CNC program message. This can be changed or disabled in the setup dialogue.

Select what you want in the drawing with the check boxes, click write

As Poly Line: The segment outline is drawn as a poly line otherwise lines are drawn.

Convergence Work Point: Draws a work point at the convergence point of the layout lines.

3D Drawing: Creates a 3D wire frame of the Cone

Open: Opens the file in your drawing editor. This option is not enabled until a file is written.